Wheatheart X160 Series - Manual (Page 143)

W HEATHEART - G RAIN A UGERS 9. A PPENDIX
X160-85, X160-105, X160-125
30875 R0 143
TO REGISTER THE FIRST TRANSMITTER:
1. Switch OFF or disconnect the power to the receiver.
2. Switch ON or reconnect the power to the receiver. This opens a 20 second
registration window in the receiver processor.
Note:
The FAULT LED on the receiver printed circuit board flashes for the duration of
this registration window.
3. Press and hold the green button until the receiver SET LED illuminates solid
red. Release button. The remote is programed, and should be set aside.
TO REGISTER A SECOND TRANSMITTER:
1. Switch OFF or disconnect the power to the receiver.
2. Switch ON or reconnect the power to the receiver and transmitters. This
opens a 20 second registration window in the receiver processor.
Note:
The FAULT LED on the receiver printed circuit board flashes for the duration of
this registration window.
3. On a 2nd transmitter, press and release the green button once, then press
and hold the green button until the receiver SET LED illuminates solid red.
Release button. The remote is programed, and should be set aside.
TO REGISTER A THIRD TRANSMITTER:
1. Switch OFF or disconnect the power to the receiver.
2. Switch ON or reconnect the power to the receiver and transmitters. This
opens a 20 second registration window in the receiver processor.
Note:
The FAULT LED on the receiver printed circuit board flashes for the duration of
this registration window.
3. On a 3rd transmitter, press and release the green button twice, then press a
third time and hold the green button until the receiver SET LED illuminates
solid red. Release button. The remote is programed, and should be set aside.
TO REGISTER A FOURTH TRANSMITTER:
1. Switch OFF or disconnect the power to the receiver.
2. Switch ON or reconnect the power to the receiver and transmitters. This
opens a 20 second registration window in the receiver processor.
Note:
The FAULT LED on the receiver printed circuit board flashes for the duration of
this registration window.
3. On a 4th transmitter, press and release the green button three times, then
press a fourth time and hold the green button until the receiver SET LED
illuminates solid red. Release button. The remote is programed, and should
be set aside.