Wheatheart X160 Series - Manual (Page 24)

2. S AFETY W HEATHEART - G RAIN A UGERS
X160-85, X160-105, X160-125
24 30875 R0
Figure 2.5 Boot Safety Decal Locations
PLACED BEHIND GUARDS
WARNING
MISSING GUARD HAZARD
To prevent serious injury or
death, shut off power and
reattach guard before operating
machine.
20803 Made in Canada
DECAL #20818
DANGER
ELECTROCUTION HAZARD
To prevent death or serious injury:
• When operating or moving, keep equipment away from overhead power lines and devices.
• Fully lower equipment and truck box before moving.
This equipment is not insulated.
Electrocution can occur without direct contact.
20816 Made in Canada
DECAL #20816
DANGER
ROTATING FLIGHTING HAZARD
To prevent death or serious injury:
• KEEP AWAY from rotating auger flighting.
• DO NOT remove or modify auger flighting
guards, doors, or covers. Keep in good
working order. Have replaced if damaged.
• DO NOT operate the auger without all
guards, doors, and covers in place.
• NEVER touch the auger flighting. Use a
stick or other tool to remove an
obstruction or clean out.
• Shut off and lock out power to adjust,
service, or clean. 20813
Made in Canada
DECAL #20813 WARNING
To prevent serious injury or death:
• Read and understand the manual before
assembling, operating, or maintaining the
equipment.
• Only trained personnel may assemble, operate, or
maintain the equipment.
• Children and untrained personnel must be kept
outside of the work area.
• If the manual, guards, or decals are missing or
damaged, contact factory or dealer for replacements.
• Lock out power before performing maintenance.
• To prevent equipment collapse, support equipment
tube while disassembling certain components.
• Electric motors must be grounded. Disconnect power
before resetting overloads.
Made in Canada 20807
DECAL #20807
DANGER
ROTATING PTO DRIVELINE HAZARD
To prevent serious injury or death:
• Keep body, hair, and clothing away from rotating PTO driveline.
• Do not operate equipment unless all driveline, tractor, and
equipment shields are in place and in good working order.
• Make certain the driveline shields turn freely on driveline.
• Make certain the driveline is securely attached at both ends.
• Do not exceed operating speed of 540 rpm.
• Keep u-joint angles small and equal. Do not exceed maximum
recommended length for PTO driveline.
Made in Canada 20818
DECAL #20803
DECAL #17107
DECAL #19960
DECAL #17904