Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 90)

Chapter 7
Installing 1771 I/O
7-2
On the 1771-A1B, -A2B, -A3B, -A3B1, -A4B chassis set the backplane
switches to determine:
last state (switch 1)
processor restart lockout (switch 2)
type of addressing (switches 5 and 6)
Set these switches before you install the adapter module.
1. Locate the eight switches located on the left side of the
chassis backplane.
2. Using the worksheet, set the I/O chassis switch assembly as indicated
with a ball-point pen (Figure 7.1). Do not use a pencil because the tip
can break off and jam or short the switch.
Figure 7.1
Set Switches on the I/O Chassis
Last State
On
Off
Processor Restart Lockout
On
Off
Addressing
Off Off
On Off
Off On
Always
Always
16191
On
On
On On
2Ćslot
1Ćslot
2
1/2Ćslot 2, 3
Not allowed
Outputs of this I/O chassis remain in their last state when a fault is
detected by this I/O adapter. 1
Outputs of this I/O chassis are turned off when a fault is
detected by this I/O adapter.
1 ATTENTION: If you set this switch to the ON position, when a fault is detected, outputs connected to this
chassis remain in their last state to allow machine motion to continue. We recommend that you set switch 1 to the
OFF position to deĆenergize outputs wired to this chassis when a fault is detected.
2 The 1771ĆAS adapter does not support 1Ćslot or 1/2Ćslot addressing. When you use this adapter, set switches 5
and 6 to the OFF position.
3 The 1771ĆASB series A adapter does not support 1/2Ćslot addressing.
The I/O chassis can be restarted from
the processor.
The processor is locked out from
restarting the I/O chassis after a fault.
12
3
4
5
6
7
8
Off (away from board) On (toward board)
Set I/O Chassis Switches