Gather the tools and supplies, Rack mount the components – Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL User Manual

Page 24

Chapter 2

Mounting the Components

2-2

Gather these tools and supplies you will need:

#10-32 screws, lock washers, flat washers and screw driver set, if you

are rack mounting

#10-32 screws, lock washers, flat washers, and drill and tapping

equipment if you are panel mounting

wrench set, if applicable
wire brush
tape measure
marker or grease pencil
copper ground bus
two spacers, for use between the ground bus and panel

To:

Then:

Panel mount the components

go to page

Rack mount the components

After you have gathered the equipment, mounting documentation, and
tools, you are ready to mount the components.

Follow these steps to rack mount the components.

1. Prepare each component.

For the 4- and 8-slot chassis, remove the brackets from the back of
the chassis, and install them on the front of the chassis for
rack mounting.

If you are using fan assembly, attach the fan assembly to the bottom
of the chassis and then mount the chassis to the rack or panel.

Remove brackets

Install brackets

19778

Gather the Tools and Supplies

Rack Mount the Components