Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 13)

Chapter 1
1-1
Preparing for Installation
This chapter lists the tasks that must be completed before you install
the hardware.
To prepare for installation, complete the following:
gather the documentation from your system designer
make sure the hardware is available
unpack the hardware
identify the hardware
While designing your system, your system designer completes
documentation that describes what to install and how. Gather the
documentation from your system designer. You will use this
documentation with the procedures in this manual to install the hardware.
If you are installing I/O, make sure you have the installation information
for each type of I/O you are installing.
You may have only some of the documentation below because you may
not be installing some of the components.
Get this information from your system designer: In chapter: To:
list of the components you will install 1 identify components
the position of the components 2 mount components
the points to ground 3 ground components
the PI modules you install, switch settings,
and connections
4 and
appendix A
install modules
other PI components you will install (industrial disk) 5 install peripherals
vision system information 6 install vision components
standard 1771 I/O 7 install standard 1771 I/O
nonĆstandard 1771 I/O 8 install nonĆstandard 1771 I/O
I/O points to wire 9 wire I/O link
ac wiring diagrams 10 connect ac power
Chapter Objectives
To Prepare for Installation
Gather the Documentation