Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL - Manual (Page 89)

Chapter 7
7-1
Installing 1771 I/O
This chapter guides you in installing your I/O. It shows you how to:
set the I/O chassis switches
set the I/O chassis configuration jumper
set the I/O adapter module switches
install keying bands and wiring arms
install I/O modules
connect wiring arms
connect your I/O to the RS module
If you are not installing I/O modules, go to the next chapter.
Make sure you have mounted and grounded your I/O chassis and power
supply as shown in chapters 2 and 3 of this manual.
Gather the I/O information from the system designer (including the
worksheet). This information should contain:
switch settings for the I/O chassis and modules
the names of the I/O modules to install and where to install them
(chassis, rack)
the I/O to wire
identification for each I/O
the I/O channel connections to make
You may also need the specific publication for each type of I/O module
you are installing.
Chapter Objectives
What You Should Have
Completed
Before You Begin