Rockwell Automation 5000,D50006.2.10 PI INSTALLATION MANUAL User Manual
Page 205
Index
I–6
illustration,
installation,
keyswitch,
ports 2A and 2B,
setting switches and jumpers,
RS,
150-Ohm termination resistor,
connecting I/O link cable,
disposal of battery,
grounding,
illustration,
installing,
module address,
start up and configure,
termination resistors,
RS-232,
RS2
changing a memory module,
run
MicroVAX Information Processor,
self-test,
power-up diagnostic self-test,
self-test on individual devices,
S
scanner. See RS,
self-test error codes, table of,
serial port
25-pin,
9-pin,
set
default boot device,
hardware defaults,
pushwheel address, OSI interface
module,
switches, OSI interface module,
set up, console terminal, MicroVAX
software
MicroVAX Information Processor, start up
and configure,
OSI interface module, start up and
configure,
specifications, power supply,
start up and test MicroVAX Information
Processor,
configure defaults,
perform power-up diagnostics,
run system exerciser,
set up terminal,
verify industrial disk,
static-safe environment,
storing, lithium battery,
switch assemblies, SW1, extendedĆlocal
I/O,
switch settings,
extended-local I/O adapter module,
switches
conventions,
direct communication module switches,
PLC interface module,
RediPANEL,
RediPANEL Keypad module,
settings, 1770-KF2, 1785-KE,
system exerciser display codes, table of,
T
table
hardware self-test error codes,
system exerciser display codes,
test numbers, device mnemonics,
terminating link, extendedĆlocal I/O,
termination resistors,
150-Ohm,
extendedĆlocal I/O,
transformers,
transmission rate,
trunkline/dropline configuration,
U
user interface box
connection
black and white monitor,