Rockwell Automation 1769-HSC Compact High Speed Counter Module - Manual (Page 50)

50 Rockwell Automation Publication 1769-UM006E-EN-P - July 2013
Chapter 3 Installation and Wiring
Mount the Module Use these procedures to mount your module.
Minimum Spacing
Maintain spacing from enclosure walls, wireways, adjacent equipment, and so
forth. Allow 50 mm (2 in.) of space on all sides for adequate ventilation,
as shown.
Panel Mounting
Mount the module to a panel by using two screws per module. Use M4 or #8
panhead screws. Mounting screws are required on every module.
ATTENTION: During panel or DIN-rail mounting of all devices, be sure
that all debris (metal chips, wire strands) is kept from falling into the
module. Debris that falls into the module could cause damage at
powerup.
ATTENTION: This product is intended to be mounted to a well-grounded
mounting surface such as a metal panel. Additional grounding
connections from the power supply's mounting tabs or DIN rail (if used)
are not required unless the mounting surface cannot be grounded. Refer
to Industrial Automation Wiring and Grounding Guidelines, Rockwell
Automation publication
1770-4.1 , for additional information.
Host Controller
Compact
I/O
Compact
I/O
Compact
I/O
Compact
I/O
Compact
I/O
End
Cap
Side Side
Top
Bottom