Rockwell Automation 1203-CN1 ControlNet Communications Module 1203-CN1 - Manual (Page 38)

Publication 1203-5.13 – February, 2002
3-10 Getting Started
4. Edit parameters as necessary using the Left Arrow and Right
Arrow keys. Refer to Navigation Techniques earlier in this
chapter for information on changing values. Refer to Appendix B,
1203-CN1 Module Parameters, for valid values.
5. If necessary, reset power to the module by enabling the Reset
Adapter parameter (22). Refer to Appendix B, 1203-CN1 Module
Parameters, to see if the parameter you changed requires the
module to be reset in order to take effect.
Displaying and Clearing the Event
Queue in the 1203-CN1 Module If an unexpected problem occurs with the module, you may need to
check the event queue to view events that have happened in the
module. Follow these instructions:
1. Establish a serial connection to access the module’s software.
Refer to the Establishing a Serial Connection with the 1203-CN1
Module section earlier in this chapter.
2. Press 3 to select 3> Display event queue. The event queue
appears.
Figure 3.11
Example Event Queue
Internal
Fault ID
Level of Fault
Description
I = information
W = warning
S = severe
F = fatal