Rockwell Automation 20Y PowerFlex Active Front End - Manual (Page 21)

Rockwell Automation Publication 20Y-UM001E-EN-P - July 2014 21
Chapter
1
AFE in IP20 2500 MCC Style Enclosure—
Installation/Wiring
This chapter provides information on installing and wiring the PowerFlex Active
Front End in a IP20 2500 MCC Style enclosure. For information on installing
and wiring the AFE in a IP21 Rittal enclosure, see
Chapter 2 .
Most start-up difficulties are the result of incorrect wiring. Every precaution must
be taken to verify that the wiring is done as instructed. All items must be read and
understood before the actual installation begins.
Topic Page
Main Component Sections 22
Main Component Locations 24
Mounting Considerations 26
AC Supply Source Considerations 28
Grounding Requirements 29
Fuses and Circuit Breakers 30
Power Wiring 31
Disconnecting Common Mode Capacitors 38
Using the AFE with PowerFlex Drives 40
Control Wiring 40
Precharging the AFE 47
CE Conformity 48
ATTENTION: The following information is merely a guide for proper installation.
Rockwell Automation cannot assume responsibility for the compliance or the
noncompliance to any code, national, local or otherwise for the proper
installation of this 700AFE or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored during installation.