Quadrox WebCCTV User Manual - Manual (Page 54)

WebCCTV User Manual 54
Version 4.9 Series
3.3.2.1.2 Configuration
This screen allows you to configure your I/O Device lines as inputs or outputs for the alarm
signals. If you don’t need all of the line(s) you can disable the unused lines.
The screen contains the picture of the I/O Device connector with 13 drop-down lists around it
which correspond to 13 lines of the I/O Device. Each drop-down list has 3 options available:
I, O and X.
Configuration (Picolo I/O Proxy) Screen
Value Description
I
Configure line as input. This line receives an alarm signal from an
external device.
O
Configure line as output. This line sends a control signal to the
external device.
X Disable the line. This line neither receives, nor sends controls signals.
Click Next to enter the next I/O Device Configuration Wizard Screen.
3.3.2.1.3 Outputs
This screen allows you to assign names to the lines you have configured as outputs.
Outputs (Picolo I/O Proxy) Screen
If you didn’t configure any line as an output, the following message will be shown: “No
outputs are currently configured for this device”. Consequently no configuration will be
available on this page.
Click the Finish button to apply the configuration.