Quadrox WebCCTV User Manual - Manual (Page 13)

WebCCTV User Manual 13
Version 4.9 Series
To access the WebCCTV server via Internet Explorer, follow the steps below:
1. Obtain the exact IP address for the WebCCTV from your System Administrator and
make note of it for future reference.
‘http://192.168.100.1/’ is the factory default IP-address for a WebCCTV. Please note
that your installer could have changed it to fit the specifications of your own network.
2. Open Internet Explorer.
Click the Start button on your PC or WebCCTV and find Internet Explorer in the
All Programs tab. An Internet Explorer link can often be found on the desktop.
3. Once Internet Explorer is opened, click on the address field and enter the IP-address as
shown in the example below (without the quotes):
‘http://192.168.100.1/’
Make sure to include the http prefix into the IP-address. This is a protocol used for
communication with a World Wide Web server. Since WebCCTV uses the same
technology, the http prefix should be included.
WebCCTV IP-address
When you changed the TCP/IP communication port, you need to add the port in the
IP-address. For example, is you changed the TCP/IP port to 81 (80 is default port),
the IP-address becomes ‘http://192.168.100.1:81/’.
If you want to connect to a WebCCTV or GuardDVR, your IP-address becomes
‘http://192.168.100.1/WebCCTV’ or ‘http://192.168.100.1/guarddvr’
If the WebCCTV is accessed for the first time with a client PC, you will need to install the
ActiveX component. Follow the instructions on your screen.
Installation of the component is done (semi) automatically on the first connection to a
WebCCTV. The installation only has to be done once.