Metal Sales Seam-Loc 24 Installation - Manual (Page 38)

© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 12/03
800.406.7387 (Corporate Office) • www.metalsales.us.com
37
SEAM-LOC 24 ® S
CULPTURED
E
AVE
O
VER
O
PEN
F
RAMING
All Eave flashings must be installed prior to panel installation.
1. Install Sculptured Eave back against previously installed Eave Plate, (see page 25 for Eave Plate installation). To hold
Sculptured Eave in place fasten to substrate with #10-16 x 1" Pancake Head fastener, 4'-0" o.c.
2. Fasten Sculptured Eave to wall with appropriate fastener, 1'-0" o.c.
3. Apply a row of Double Bead Tape Sealant across Sculptured Eave so that sealant is centered over top leg of Eave Plate.
4. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a
bead of Tube Sealant between the flashings and securing with Pop Rivets, 2 1 /
2
" o.c.
5. Once panels and inside closures have been installed and properly sealed, (See page 26), fasten through panel, Double Bead Tape
Sealant, and Sculptured Eave into Eave Plate with (6) #12-14 x 1 1 /
4
" Self Driller XL screws per panel.
1 /
4
:12 Slope
Minimum
Double Bead Tape Sealant
Eave Plate
#12-14 x 1" SD N/W (1'-0" o.c.)
Seam-Loc 24 Metal Inside Closure
# 1 /
4
-14 x 7 /
8
" Stitch XL (1'-0" o.c.)
Seam-Loc 24 Sculptured Eave
#12-14 x 1" SD N/W
Double Bead Tape Sealant
Tube Sealant on Male Leg
Seam-Loc 24 Fastening Pattern
D. B. T. S.
#12-14 x 1" SD N/W
Metal
Inside
Closure
#12-14 x 1 1 /
4
" SD XL
2 6 5 4
1 3
INSTALLATION NOTES
Tube Sealant on Male Leg
Double Bead Tape Sealant