Metal Sales Seam-Loc 24 Installation - Manual (Page 32)

© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 12/03
800.406.7387 (Corporate Office) • www.metalsales.us.com
31
SEAM-LOC 24 ® I
NSTALLATION OF
P
ANEL
(
CONT
.)
6. Nest the flat of the peak panel into the eave panel.
7. Apply a pig tail of Endlap Pad on the top side of the male leg where panel notch occurs.
Set Peak Panel in Endlap Pad
Install Endlap Fasteners
5 3
1 2 4
Hold flat of Peak Panel up at lap
Lap Male Legs
Lap Female Legs
Peak Panel
Eave Panel
ENDLAPPING OF PANEL (CONT.)
Seam-Loc 24 Eave Panel
Seam-Loc 24 Peak Panel
8. Install four (4) #12-14 x 1 1 /
4
" Self Driller XL Screws where
the peak panel laps over the eave panel and
fasten in accordance with fastening pattern sequence shown below.
9. Repeat previous steps for subsequent endlaps.
Pigtail of sealant on male leg
6 7 8
ENDLAPPING SEQUENCE OVERVIEW