Lenze E94AYCCA - Manual (Page 34)

E94AYCCA communication manual (CANopen®)
Commissioning
Possible settings via DIP switches
34
L
EDS94AYCCA EN 5.0 - 06/2012
6.2.2 Setting the baud rate
 The baud rate can be set with the DIP switches a ... d or via the »Engineer« (code
C13351 / C14351 ).
 If several CAN nodes are interconnected, their baud rates must be identical.

Tip!
The baud rate resulting from the DIP switch setting applied at last mains power-up
is indicated under C13349/2 / C14349/2 .
Switch positions Baud rate
d c b a
OFF ON ON OFF 10 kbps
OFF ON OFF ON 20 kbps
OFF OFF ON ON 50 kbps
OFF OFF ON OFF 125 kbps
OFF OFF OFF ON 250 kbps
OFF OFF OFF OFF 500 kbps
ON ON ON OFF 800 kbps
OFF ON OFF OFF 1000 kbps
OFF ON ON ON Automatic detection

Note!
Switch the voltage supply of the standard device off and then on again to
activate altered settings.