13 parameter reference, C00369 | can sync transmission cycle time, Parameter reference – Lenze E94AYCCA User Manual
Page 101: C00369/1, E94aycca communication manual (canopen®)
EDS94AYCCA EN 5.0 - 06/2012
L
101
E94AYCCA communication manual (CANopen®)
Parameter reference
Communication-relevant parameters of the standard device
13
Parameter reference
This chapter supplements the parameter list and the table of attributes in the software
manual and the »Engineer« online help for the Servo Drive 9400 by the parameters of the
E94AYCCA communication module (CANopen).
13.1
Communication-relevant parameters of the standard device
In this chapter communication-relevant parameters of the Servo Drive 9400 are listed in
numerically ascending order.
C00369
Software manual/»Engineer« online help for Servo Drive 9400
Here you will find general information about parameters.
Parameter | Name:
C00369 | CAN sync transmission cycle time
Data type: UNSIGNED_16
Index: 11206
d
= 2BC6
h
Cycle within which the sync master is to send sync telegrams.
• With "0 ms" (Lenze setting), no sync telegrams are created.
• Mapping of the CANopen object
(see DS301, V4.02).
Synchronisation of PDOs via sync telegram ( 50)
Setting range
(min. value | unit | max. value)
0
ms
65535
Subcodes
Lenze setting
Information
C00369/1
0 ms
Transmission cycle time for CAN on board
C00369/2
0 ms
Transmission cycle time for CAN module in MXI1/MXI2
C00369/3
0 ms
No function
;
Read access ; Write access CINH PLC STOP No transfer
Scaling factor: 1