Figure 40, Final alignment and securing of gasket band -36, Figure 41 – CiDRA SONARtrac PW VF-100 User Manual
Page 54: Band termination -36, Figure 42, Stainless steel cover assembly -36
20831-01 Rev 05
Page 5-36
Upper cover assembly
Lower cover assembly
Transmitter cable connector
socket
Sensor cable access panel
Cover lifting handles (4 plcs)
Boot Gasket (upper &
lower covers
Tighten the set screw to lock the band in place. The band will be
dimpled by the set screw.
Figure 40 Final Alignment and Securing of Gasket Band
Once the set screw has been fully tightened, loosen the tensioning
tool and bend the tool and band up and over the buckle. It is not
necessary to cut excess band material (allows for re-tightening or re-
use of band if necessary).
Repeat the band installation procedure for the opposite end of the
cover.
Figure 41 Band Termination
The completed stainless cover assembly is shown below
Figure 42 Stainless Steel Cover Assembly
Boot gasket tight against pipe
Buckle over protector plate
Allen wrench tightening
set screw on buckle
Band bent back
over buckle