CiDRA SONARtrac PW VF-100 - Manual (Page 40)

20831-01 Rev 05 Page 5-22
5.7.1 Fiberglass Cover Model SH-XXX-XX-XA-XXX-XX Installation
The installation procedures for Fiberglass Cover Model Number SH-
xxx-xx-xA-xxx-xx (where
“x” is any alphanumeric character) is found
on the following pages. These covers are readily recognized by their
having latches and strikes to secure the cover halves together. Note:
These are the only model number covers currently available with
ATEX Zone 2 certification.
Important: A banding tool is needed to properly install sensor cover
sizes 10-inch and larger. Failure to use a banding tool may result in
improper sensor cover to pipe sealing and will void the system
warranty. The use of a BAND-IT
®
Model C00169 Banding Tool (or
equivalent) is recommended. The tool is available through Customer
Support as P/N 52511-01. This tool is also available in the United
States from McMaster Carr Company (telephone 630-833-0300,
internet www.mcmaster.com) as their P/N 5424K1. Other suppliers
are available worldwide. Contact BAND-IT at 800-525-0758 or 303-
320-4555 or www.band-it-idex.com.
Figure 18 BAND-IT
®
Model C00169 Banding Tool
CAUTION
Use of a BAND-IT
®
Model C00169 Banding Tool (or equivalent) is
necessary for properly installing sensor cover. Failure to use
this tool may void system warranty.