CiDRA SONARtrac PW VF-100 - Manual (Page 120)

20833-01 Rev 04 Page 7-26
Table 10 (page 2) VF Transmitter Menu Tree Software Release 04.02.XX
Level 1 Level 2 Level 3 Range Description
Output Config
4-20mA
Ch1& Ch2
Output Sel
Flow Rate, Flow
Quality, Blank
Parameter to output
Power Sel Internal, External
Power supply for 4-
20mA current
Low End Based on ‘output sel’ Low end output (4mA)
High End Based on ‘output sel’ High end output (20mA)
Out of Range
Hold, >20mA, <4mA,
4mA
Behavior when meter
reading is out of range
or meter has no reading
Overrange
Rail
Enable, Disable
‘Enable’ causes the
output to go to full
(20mA) or min (4mA)
when system over
ranges
4mA Trim 2 to 6 Adjust 4mA output
20mA Trim 18 to 22 Adjust 20mA output
Pulse
Multiplier 0 - 999999 Multiplier on output
Width (ms) .5,1,20,33,50,100 Pulse width
Lowcut 0% to 100% Low end cutoff
Output Sel
Flow Rate, Flow
Quality, Totalizer, Flow
Rate%
Parameter to output
Alarm
Control
Warning Off/On/Equation Input
Activates alarm warning
function
Critical Off/On/Equation Input
Activates alarm critical
function
Manual Clear Enable / Disable
Allows for manual or
automatic alarm
clearing
Alarm
Warning
Threshold
Flw Min
0-100% of range
Used to set the
minimum and maximum
values for a warning
alarm
Flw Max
Alarm Critical
Threshold
Flw Min
0-100% of range
Used to set the
minimum and maximum
values for a critical
alarm
Flw Max
Flow
Damping
Filter State Enable, Disable Enable Damping
Time
Constant (s) 0-600 seconds; default
is 3 Smoothes output due to
rapid changes in flow
Flow Noise
Filter State Enable, Disable Enable noise filtering
Magnitude Low, High Amount of damping