CiDRA SONARtrac PW VF-100 - Manual (Page 172)

20834-01 Rev 04 Page 8-28
8.7.7 Monitor
Monitor displays a set of various ‘System’ or ‘Sensor’ parameters,
updated at the display update rate. Used by Factory Technical
Support personnel.
8.7.8 Pulse Test
Pulse Test is used to test the functionality of the pulse output. Set the
Pulses Per Second and the Pulse Width and the output will update
immediately. Refer to Section 8.2.2.3 Table 1 for the maximum pulse
rate at a given pulse width.
8.7.9 Alarm Test
The Alarm Test allows the user to set the Alarm Output to a know
state:
8.8 Info Menu
The ‘Info’ menu allows the user to get detailed information on the flow
monitoring syste
m. The ↑ and ↓ keys scroll through the pages in the
Info menu.
8.8.1 Revisions
Revisions provides a multi-page list of installed system revisions,
hardware / software serial / model numbers and part numbers.
8.8.2 Diagnostics
Diagnostics provides a multi-page list of system, temperatures,
voltages, and status messages.
8.8.3 Configuration
Configuration provides a multi page list (summary) of system setup
parameters.
8.8.4 Event Log
Event Log displays a list of events, stored in non-volatile memory.
Every event (up to 65,535 occurrences) is stored in the transmitter
event log file. The latest 10 events are time stamped.
Pressing the up and down arrow keys will page up and down through
all events. Pressing the ‘→’ arrow will display a prompt to erase the
‘Event Log’. Press ‘→’ arrow again to erase. To cancel the erase
function, press any key other than ‘ENTER’.