CiDRA SONARtrac PW VF-100 - Manual (Page 110)

20833-01 Rev 04 Page 7-16
7.6.1.2.2 Status Line
The code for information in the status line shown in Figure 52 is
defined as follows:
ID Characters Description Values
S 20 Status Messages See Status Messages Table below
Q 11 Quality Field See Quality Field Message Table below
M 4 Mode See Operating Mode Message Table below
E 1
Ethernet
Communication
E – Ethernet activity present
C 1
Other
Communications
H - Hart Message received
M - MODBUS communications
M (reverse)
– MODBUS in write mode
F – Fieldbus
F (reverse) – Fieldbus in write mode
S - Serial Activity
Blank - No Activity
W 1 Write Protect
W – Write Protected or
[blank] – Not Write Protected
E 1 Event Log Updated
! – Event Log Updated or [blank] – No change to
Event Log since last check
A 1 Activity |/-\ (Cycle changes indicate activity)
Table 3 Status Line Code
Status Messages -
‘S’:
A number of status messages can be displayed in the 20 character
status message field. They are as follows:
Status Message Description
INITIALIZE MODE DSP is acquiring data to calculate a measurement
VF INITIALIZE MODE DSP is acquiring data to calculate a flow measurement
BELOW MIN VF QUALITY
Quality of measured sensor data is below a configured
minimum for a Vortical Flow measurement
GVF INITIALIZE MODE
DSP is acquiring data to calculate a GVF
measurement
INVALID SOS DATA
DSP is acquiring data to calculate a SOS
measurement
BELOW MIN SS QUALITY
Quality of measured sensor data is below a configured
minimum for a GVF measurement
BELOW MIN QUALITY
Quality of measured sensor data is below a configured
minimum for VF and SOS measurement
SENSOR OVERLOAD DSP indicates sensors are overloaded
DSP FAILURE - n A DSP communication error occurred
Table 4 Status Line Messages