CiDRA SONARtrac PW VF-100 - Manual (Page 167)

20834-01 Rev 04 Page 8-23
8.5 Customize Menu
The Customize menu is used to configure the transmitter to meet user
requirements for local display of measurement parameters.
8.5.1 Display
The display parameters are used to customize the displayed units and
appearance of the display.
8.5.1.1 Line 1 and Line 2
Line 1 and Line 2 set the outputs of the display lines to ‘Totalizer’,
’Flow Rate %’, ‘Flow Rate’, ‘True Liquid Flow’, ‘GVF’, ’SOS’, and
‘Blank’ (depending upon system configuration).
8.5.1.2 Contrast
Contrast is used to adjust the screen appearance due to lighting
conditions. Normally this is set to 170.
8.5.2 Sensor Setup
8.5.2.1 State
State is used to turn indiv
idual sensors ‘On’ or ‘Off’. Normal operating
condition is with all sensors set to ‘On’. Sensors should only be
turned off under the direction of Technical Support Personnel.
8.5.3 Flow Units (Systems with Flow)
8.5.3.1 Volume
The menu selectable units for ‘Volume’ are ‘gal’ (gallons), ‘l’ (liters),
‘m
3 ‘, (cubic meters), ‘user’ (user defined), ‘iga’ (imperial gallons), ‘ft 3 ‘
(cubic feet), ‘ft’ (feet), ‘m’ (meter).
8.5.3.2 Time
The menu selectable units for ‘Time’ are ‘s’ (second), ‘m’ (minute), ‘h’
(hour), ‘d’ (day), ‘user’ (user defined).
In both the ‘Volume’ and ‘Time’ selections custom user labels can be
input by the user by selecting ‘user’ from the menu. The user defined
labels are then input using the ‘User Volume / Time’, ‘Base’, and
‘Scale Factors’.
8.5.4 SOS Units (Systems with GVF)
The menu selectable SOS Units are ‘ft’ (feet) and ‘m’ (meter). The
units of time measure are fixed to be in seconds. Hence, the output of
SOS is in units of ‘ft/s’ or ‘m/s’.