Eppendorf BioSpectrometer kinetic - Manual (Page 48)

Methods
Eppendorf BioSpectrometer
® kinetic
English (EN)
48
Bacterial
density Results display:
• Calculated result with absorbance at
the measuring wavelength.
• If activated in the parameters: Scan.
Navigate between the measuring
points in the graph with and .
Basic main group
Factor,
standard Analog to Protein direct UV (see above) Results display:
• Concentration result with absorbance
at the measuring wavelength.
Calibration
curve Analog to Proteins (with reagent) (see above) Results display:
• Concentration result with absorbance
at the measuring wavelength.
• Graph of the standard evaluation with
plotted sample result.
Simple
kinetics Prior to measurement:
• Check parameters method step:
Display temperature control. When the
temperature set in the parameters has
been reached and the display changes
from
Tempering to Ready, you can go
to the measurement.
Results display:
• Concentration result with absorbance
or A/min with the measuring
wavelength.
• Only for the "linear regression"
measuring procedure: graph with
absorbance time display and plotted
regression line.
Navigate between the measuring
points in the graph with and .
Additional data ([Data] softkey):
Dependent on the measuring procedure:
• Absorbance time value pairs for the
first and last measuring points
("endpoint" method: only one
measuring point).
• Quality parameters for linear
regression (omitted for kinetics with a
slope below 0.050 E/min).
Method group Results display Explanation