Eppendorf BioSpectrometer kinetic - Manual (Page 24)

Operation
Eppendorf BioSpectrometer
® kinetic
English (EN)
24
5.3.2.3 Measuring the blank and standards
5.3.2.4 Measuring samples
For evaluations without standards (e.g. DNA measurements), this method step is omitted.
1. Start by measuring a blank ( blank key).
2. Then measure all standards one by one
( standard key).
The display always marks the standard that is to be
measured next. Use the [Graph] resp. [Table]
softkey to change the result view.
 Press [Next] to accept the evaluation calculated
from the standard results.
 The sample key is used for measuring your
samples consecutively.
Blank results will remain saved for the duration of
one series of measurement. However, a new blank
measurement always is possible. (The adjacent
figure shows a measuring procedure with
evaluation via the standard curve and, in addition
to the sample result, the graph of the standard
evaluation.)