Eppendorf BioSpectrometer kinetic - Manual (Page 15)

15
Installation
Eppendorf BioSpectrometer ® kinetic
English (EN)
4 Installation
4.1 Preparing installation
 Keep the transport carton and the packing material for subsequent safe transport or storage.
 Check the completeness of the delivery using the information in the delivery package (see Delivery
package on p. 9).
 Check all parts for any transport damage.
4.2 Selecting the location
Select the location for the BioSpectrometer kinetic according to the following criteria:
• 2 grounded sockets for the BioSpectrometer kinetic and for the printer.
• Solid laboratory bench with horizontal work surface
Space requirement of the device: 50 cm (with printer: 75 cm) width, 50 cm depth.
• Temperature: 15°C to 35°C.
• Avoid temperature fluctuations (e.g, caused by open windows).
• Avoid direct sunlight.
• Humidity: 25% to 70% relative humidity.
4.3 Connecting the device to the mains
1. Place the BioSpectrometer kinetic on a suitable work surface.
2. Verify that the mains/power supply voltage and mains/power frequency match the information on the
name plate.
3. Connect the device to the mains/power line and switch it on with the power switch.
4. Remove the protective film from the display.
4.4 Connecting the printer
4.4.1 Thermal printer DPU-S445
Prerequisites
Software version 3.4.4.0 or higher is installed on the device.
Connect the thermal printer DPU-S445 to the USB port for printers.
1. Connect the printer cable with the USB port for printers 4 (see Main illustration on p. 9).
2. Connect the printer cable with the printer.
3. Connect the printer to the mains/power line using the supplied mains/power adaptor and mains/power
cord (printer accessory) and switch it on.
For information on the printer, refer to the operating manual of the printer.
Ensure that no objects (e.g., loose sheets, notebooks) that could impede the flow of air are
positioned under the device.