Brocade BigIron RX Series Hardware Reference Manual - Manual (Page 32)

20 Brocade BigIron RX Series Hardware Installation Guide
53-1002483-03
Supported software features
1
CAUTION
To avoid overheating of the BigIron RX Series chassis, do not remove more than one fan at a time.
Rack mount kit
The BigIron RX Series switches are shipped equipped for mounting in a standard 19-inch
(EIA310-D) rack as described:
• The BigIron RX-4 and BigIron RX-8 are equipped with built-in mounting brackets and are
shipped with mounting screws.
• The BigIron RX-16 switches ship with two L-shaped mounting brackets and mounting screws.
Alternatively, you can use a mid-mount kit (ordered separately) to center-mount the BigIron RX
chassis using two L-shaped mounting brackets. The mid-mount kit comes with instructions for
installing the mounting brackets and mounting the device in a rack.
Contact Brocade Communications Systems, Inc for information about mid-mount kits.
In a rack, you can install the following number of BigIron RX Series chassis depending on the
model:
• BigIron RX-16 – up to 3 BigIron RX-16 chassis
• BigIron RX-8 – up to 6 BigIron RX-8 chassis
• BigIron RX-4 – up to 10 BigIron RX-4 chassis
Supported software features
For a complete list of software features supported on the BigIron RX Series switch, refer to the
software release notes for this device. For information about configuring basic, non-protocol
software features supported on this device,refer to the BigIron RX Series Configuration Guide.
TABLE 8 Fan control module LED
LED Position State Meaning
Fan control module
LED Rear of chassis Off The fans are not receiving power.
Green The fans are working and responding to
controls from the fan control module.
Amber The fans are not working and not responding
to controls from the fan control module.