Brocade BigIron RX Series Hardware Reference Manual - Manual (Page 139)

Brocade BigIron RX Series Hardware Installation Guide 127
53-1002483-03
Displaying flash memory and version information
6
LP Kernel Image (Monitor for LP
Image Type 0) Indicates the interface module Boot-Monitor image stored in the
management module’s code flash. The management module stores these
images only; it does not run the images. The image name format is
described in
“Software image naming conventions” on page 123. The
output displays the following information about the image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
LP IronWare Image (Primary or
Secondary for Module Type 0) Indicates the interface modules’ primary or secondary IronWare image
stored in the management module’s code flash if you copied the primary or
secondary IronWare image to all interface modules using the copy
command with the all keyword. The management module stores these
images only; it does not run the images. The image name format is
described in
“Software image naming conventions” on page 123. The
output displays the following information about the image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
Boot-Monitor Image Indicates the monitor image installed in the management module’s code
flash. The image name format is described in
“Software image naming
conventions” on page 123. The output displays the following information
about the image:
•
Version – “2.3.0Txxy” indicates the image version number. The “Txxy”
is used by Brocade for record keeping. The “xx” indicates the hardware
type, while the “y” indicates the image type.
•
Size – The size, in bytes, of the image.
•
Check sum – A unique ID for the image. If the contents of the image
change, the check sum changes also.
•
Compilation date and time – The date and time that Brocade compiled
the image.
Startup Configuration The output displays the following information about the startup
configuration, which is saved in the management module’s code flash:
•
Size – Size, in bytes, of the startup configuration.
•
Check sum – A unique ID for the file. If the contents of the file change,
the check sum changes also.
•
Modification date and time – Date and time that the startup
configuration was last saved.
Boot Flash The model number and size of the management module’s boot flash.
TABLE 23 Code flash and boot flash information (Continued)
This field... Displays...