Brocade BigIron RX Series Hardware Reference Manual - Manual (Page 142)

130 Brocade BigIron RX Series Hardware Installation Guide
53-1002483-03
Upgrading the BigIron RX Series software
6
Boot : Version 2.7.3T155 Copyright (c) 1996-2010 Brocade Communications
Systems, Inc.
Compiled on Aug 27 2010 at 01:23:18 labeled as rlb02703
(307473 bytes) from boot flash
Monitor : Version 2.7.3T155 Copyright (c) 1996-2010 Brocade Communications
Systems, Inc.
Compiled on Aug 27 2010 at 01:23:18 labeled as rlb02703
(307473 bytes) from code flash
IronWare : Version 2.7.3T157 Copyright (c) 1996-2010 Brocade Communications
Systems, Inc.
Compiled on Aug 27 2010 at 01:51:10 labeled as rlp02703
(2334914 bytes) from Primary
FAP 1 version: 3
FAP 2 version: 3
FAP 3 version: 0
FAP 4 version: 0
660 MHz Power PC processor 440GP (version 8020/0020) 330 MHz bus
512 KB Boot Flash (AM29LV040B), 16 MB Code Flash (MT28F640J3)
512 MB DRAM, 8 KB SRAM, 0 Bytes BRAM
LP Slot 1 uptime is 11 minutes 57 seconds
.
.
.
==========================================================================
All show version done
Syntax: show version
Upgrading the BigIron RX Series software
This section describes the upgrade procedures required to operate a BigIron RX. Read this section
before you upgrade the BigIron RX software. It contains the following information:
• “Changes to software images starting with version 02.5.00”
• “Unified software image upgrade to upgrade release 02.6.00 and later”
• “Upgrading software releases prior to release 02.2.01”
• “Hitless Layer 2 OS upgrade”
• “Basic tasks in the software upgrade process”
• “Upgrading the management module monitor and boot images”
• “Upgrading the IronWare image on a management module”
• “Rebooting the management module”
• “Upgrading the MBRIDGE FPGA on the management module”
Changes to software images starting with version 02.5.00
Depending on the versions you are upgrading from or to, the procedures can be different. Follow
the procedures described in the following sections:
• “For interface modules running versions earlier than 02.3.00”
• “Separation of boot and monitor images”
• “Upgrading to version 02.5.00 (or later) from a pre- 02.5.00 version”