Xerox WorkCentre M24-2780 - Manual (Page 78)

1–36
U S E R G U I D E (C O P I E R )
Programming the Paper Supply for Tray 5 (Bypass)
You must select the paper size and paper type when loading
paper into Tray 5 (Bypass). Auto Size Detect can be used with
standard size paper.
1
On the Basic Copying tab select More… under Paper Supply.
2
Select Tray 5 (Bypass) to display the Tray 5 (Bypass) screen.
3
Perform one of the following to select Paper Size:
• Select Auto Size Detect.
• Select Standard Size.
•
Select the paper size from the list. Use the up and down
arrows to see more selections.
• Select Non-standard Size and enter in the X (width) and Y
(length) dimensions by using the arrows.
•
Press the left or right arrows to decrease or increase the X
dimension (140-483mm).
• Press the up or down arrows to increase or decrease the Y
dimension (100-305mm).