Xerox WorkCentre M24-2780 - Manual (Page 135)

1–93
U S E R G U I D E (C O P I E R )
Finisher (Optional Accessory)
The WorkCentre 24 printer/copier may be equipped with an
optional Finisher. The Finisher contains the following components:
Finisher Cover Button Provides access to the Finisher paper path.
Finisher Tray Completed jobs are delivered to this tray.
Finisher Front Door Provides access to the Stapler area.
Staple Cartridge Load a new staple pack when needed.
Finisher Stand Supports the Finisher and may be used for storage.
Finisher Interface Delivers the copies to the Finisher.
Center Tray Exit Cover Provides access to the paper path.
WARNING: Never cheat the safety interlock switch. Injury or
a document jam may occur. This switch shuts off the Finisher
power when you open the front door or when you move the
Finisher to the right to clear a paper jam.
Using the Finisher
The Finisher can staple from 2 to 50 sheets (50-sheet maximum
applies to up to 24lb / 90 gsm paper.) You can staple both portrait
and landscape documents with single or dual staples. Output to
the Finisher Tray is delivered face down. The Finisher Tray can
hold up to 1000 sheets.
• Jobs containing more than 50 sheets will not be stapled.
• Tray 5 (Bypass) cannot be selected as the paper source for a
job going to the Finisher.