Xerox WorkCentre M24-2780 - Manual (Page 391)

4–57
U S E R G U I D E (M A C H I N E A D M I N I S T R A T O R )
Contrast Level Set the default density assigned to Lower ~ Higher for Contrast in
Lighter/Darker/Contrast on the Image Quality screen. Contrast
Settings are not enabled when Output Color is set to Black. Set
the density between -100 ~ +100 in increments of 1.
Lower ~ Slightly Lower must be set between -100 and -1, and
Slightly Higher ~ Higher must be set between +1 ~ +100.
Standard, 0, cannot be changed. Set so that the values increase
from Lower to Higher.
Select Contrast using the up and down arrow buttons on the left,
and set the values using the up and down arrow buttons on the
right. The defaults from the top are, -50, -25, 0, 25, 50.
Color Space Set the default for Color Space.
Enter the setting on the Numeric Keypad using the numbers listed
in the following table. The default is 0, sRGB.
NOTE: You can find profile data on the Driver CD.
Setting Description
0 sRGB output
1 Output by device RGB. This limits the file
format to TIFF (with ICC profile). Profiles are
used to enable output at tones close to those
of the machine.