Xerox WorkCentre M24-2780 - Manual (Page 423)

5–17
U S E R G U I D E (T R O U B L E S H O O T I N G )
Deletions on the copy
edges. – Edge deletion on all sides of the copy is normal, and is greatest
on the lead edge of the copy. Set the Border Erase feature,
Variable Erase option, to 4mm to minimize the deletion. Select
the size for the original document on the Scan Options tab and an
appropriate setting from the Reduce/Enlarge option from the
Basic Copying tab.
– Moisture may be present in the paper. Load a fresh supply of
paper into the trays.
– Some deletions may be caused by small pieces of paper
remaining in the printer/copier components after a paper jam has
been cleared. When clearing a paper jam, be sure to look for and
remove any paper fragments.
Copies made from
photographs show
color or background on
output edges Most emulsions used to develop photographs have color. Sometimes
this color shows on the border of the photograph. To prevent the
color from being copied as part of the image or as background, use
one of the following suggested solutions:
– Select Background Suppression in the Image Quality Presets
feature on the Image Quality tab.
– Use the Border Erase feature on the Added Features tab to
deliberately erase the unwanted color or background from the
edge.
The copies made using
100% Reduce/Enlarge
feature do not include
the entire image along
the edge of the
document. Select the Original Size feature and program the exact size of the
dark bordered document that you wish to copy.
Output is too light Use the Lighter/Darker feature to select a darker level. Select the
Text or Maps option in the Original Type feature.
Output is too dark Use the Lighter/Darker feature to select a lighter level. Select the
Photo option in the Original Type feature
Output has too much
contrast – Select less Contrast (toward Lower) on the Light/Dark/Contrast
feature on the Image Quality tab.
– Select less Color Saturation (toward Lower) on the Sharpness/
Saturation feature on the Image Quality tab.
Output has low
contrast – Select more Contrast (toward Higher) on the Light/Dark/Contrast
feature on the Image Quality tab.
– Select more Color Saturation (toward Higher) on the Sharpness/
Saturation feature on the Image Quality tab.
Problem Suggested Solution