Xerox 4590 User Manual
Page 98

Xerox 4590/4110 Copier/Printer System Administration Guide
5-6
5. Using the Scan Service
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
–
POP3 Server - Server Name
Enter if
Specify by the IP Address
has been selected
for
POP3 Server - Setup
.
–
POP3 Server - Port Number
Enter a value in the range from 1 to 65535.
–
POP3 Server - Server Check Interval
Set the interval for checking the e-mail on the POP3
server.
–
POP3 Server - Server Name
Enter the name to login to the POP3 server.
–
POP3 Password
Enter the same password twice in the
New Password
and
Confirm Password
. If you do not wish to set the
password, leave it blank and select
Save
.
–
POP3 Password Encryption
Select
ON(APOP)
to encrypt the password.
•
Select
Save
and then select
Close
.
4.
Configure the mail transmission
•
Select
SMTP Server Settings
and then set the following
items for the SMTP server.
–
SMTP Server - Setup
Select from
Specify by the IP Address
or
Specify by
the Server Name
.
–
SMTP Server - IP Address
Enter if
Specify by the IP Address
has been selected
for
POP3 Server - Setup
.