Xerox 4590 - Manual (Page 39)

Xerox 4590/4110 Copier/Printer System Administration Guide 2-5
2. Configuration
Supported interfaces
• 100Base-TX
• 10Base-T
Supported frame types
• Ethernet II specification
• IEEE802.3 specification
• IEEE802.3 / IEEE802.2 specification
• IEEE802.3 / IEEE802.2 / SNAP specification
NOTE: The machine will send packets of each frame type on the
network, and will initialize for the same frame type as the first reply
packet received. However, if there are multiple protocols running
on the same network, use Ethernet II specification.
Configuration on the machine
This section describes the configuration procedure to connect the
machine to a NetWare network.
NOTE: Configuration can also be performed using the Network
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
Refer to “Using CentreWare Internet Services” on page 3-1.
1. Confirm the device name and network address.
Print the
Printer Settings List
to confirm the device name and
network address printed under the NetWare item.
2. Configure the machine using the “CentreWare Utilities”
CD-ROM.
There is no need to activate the NetWare port on the machine
prior to configuration when using the “CentreWare Utilities”
CD-ROM.
Refer to the manual contained in the “CentreWare Utilities”
CD-ROM for the configuration procedure.