Xerox 4590 User Manual
Page 51

Xerox 4590/4110 Copier/Printer System Administration Guide
3-3
3. Using CentreWare Internet Services
c. Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Manual
. If you select anything other than
Manual
, proceed
to step 4.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.
d. Select
TCP/IP - Get IP Address
and then select
Change
Settings
.
e. Enter the IP address using the numeric keypad.
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx" where
xxx should be a numeric value in the range from 0 to 255.
However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot
be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
f. Select
Save
.
g. Configure
TCP/IP - Subnet Mask
and
TCP/IP - Gateway
Address
as the above.
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx" where
xxx should be a numeric value in the range from 0 to 255.
However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot
be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255.However, you
cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address, enter
"0.0.0.0."
4.
Select
Close
repeatedly until the
System Settings
screen is
displayed.
5.
Select
Exit
.
6.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the Internet service port is enabled.