beautypg.com

Configuring the e-mail environment – Xerox 4590 User Manual

Page 96

background image

Xerox 4590/4110 Copier/Printer System Administration Guide

5-4

5. Using the Scan Service

NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.

NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.

NOTE 3: If you do not wish to set the gateway address,
enter “0.0.0.0.”

4.

Select

Close

repeatedly until the

System Settings

screen is

displayed.

5.

Select

Exit

.

6.

After the machine is restarted, print out the Printer Settings
List to confirm that the mail send port is enabled and TCP/IP is

configured.

Configuring the E-mail environment

This section describes the configuration procedure to use the

scanner (mail transmission) function.

NOTE 1: The configuration can also be performed using
CentreWare Internet Services.

NOTE 2: Enable the SOAP port and the SNMP port in most cases.

Refer to “Using CentreWare Internet Services” on page 3-1.

1.

Display the

System Administrator Menu

screen.

a. Press the

Log In/Out

button.

b. Enter the UserID using the numeric keypad and then

select

Confirm

.

NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.

c. Select

System Settings

.

This manual is related to the following products: