Xerox 4590 - Manual (Page 113)

Xerox 4590/4110 Copier/Printer System Administration Guide 5-21
5. Using the Scan Service
Overview
This section describes the configuration procedure to use the
scanner (save to a computer) function on the machine.
The following is the procedure to use the scanner (save to a
computer) function:
•
Enabling the port and setting TCP/IP
Enable the FTP port or SMB port and set the machine's IP
address.
• Preparing a FTP folder or SMB folder
Create a folder for transmission destinations on the computer.
NOTE: When using with SMB protocol, you must login to the FTP
server of your choice and create a destination directory for your
files.
Enabling the ports and setting the IP addresses
In order to use the scanner (save to a computer) service, enable a
port (SMB or FTP client) and set the IP address. The procedure
for setting the machine is as follows:
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to “Using CentreWare Internet Services” on page 3-1.
1. Display the
System Administrator Menu
screen.
a. Press the
Log In/Out
button.
NOTE: If the password is set, the Login screen is
displayed.
b. If the password is set, enter the password using the
numeric keypad and select
Confirm
. If the password is not
set, proceed to step c.
NOTE: The default value for the password is 11111.
c. Select
System Settings
.
2. When using the SMB protocol, enable the SMB port.
a. Select
System Settings
.
b. Select
Network Settings
.
c. Select
Port Settings
.
d. Select
SMB
and then select
Change Settings
.