Stamp position defaults – Xerox 4590 User Manual
Page 264

Xerox 4590/4110 Copier/Printer System Administration Guide
8-106
8. Setups
Stamp Position defaults
You can select the default position that the stamp is printed on the
output when the
Stamp
feature is selected on the
Annotation
screen (
Output Format
tab). There are nine stamp position
defaults:
•
Stamp Position - Top Left
•
Stamp Position - Top Center
•
Stamp Position - Top Right
•
Stamp Position - Left Center
•
Stamp Position - Center
•
Stamp Position - Right Center
•
Stamp Position - Bottom Left
•
Stamp Position - Bottom Center
•
Stamp Position - Bottom Right
Select a setting for each one of these stamp positions. When you
select a specific
Stamp Position
on the
Annotation
screen
(
Output Format
tab), such as
Top Left
, the setting selected here
defines exactly where on the top left of the output the stamp is
printed.
You can fine tune the default stamp position in both the horizontal
and vertical directions:
•
For
Top Left
, you can set the horizontal position within a range
of
0-100
in 1 mm increments, and in the vertical position within
a range of
0-100
in 1 mm increments.
•
For
Top Center
, you can set the horizontal position within a
range of
0-100
in 1 mm increments, and in the vertical position
within a range of
0-200
in 1 mm increments
•
For
Top Right
, you can set the horizontal position within a
range of
0-100
in 1 mm increments, and in the vertical position
within a range of
0-100
in 1 mm increments
•
For
Left Center
, you can set the horizontal position within a
range of
0-200
in 1 mm increments, and in the vertical position
within a range of
0-100
in 1 mm increments
•
For
Center
, you can set the horizontal position within a range
of
0-200
in 1 mm increments, and in the vertical position within
a range of
0-200
in 1 mm increments
•
For
Right Center
, you can set the horizontal position within a
range of
0-200
in 1 mm increments, and in the vertical position
within a range of
0-100
in 1 mm increments