beautypg.com

Xerox 4590 User Manual

Page 95

background image

Xerox 4590/4110 Copier/Printer System Administration Guide

5-3

5. Using the Scan Service

2.

Enable the ports which are used for the scanner (mail
transmission) function.
a. Select

System Settings

.

b. Select

Network Settings

.

c. Select

Port Settings

.

d. Select

Send E-mail

and then select

Change Settings

.

e. Select

Send E-mail - Port

and select

Change Settings

.

f. Select

Enable

and then select

Save

.

g. Select

Close

repeatedly until the

Network Settings

screen is displayed.

3.

Set the IP address.
If the IP address is already set, this step is not necessary.

Also, in an environment with DHCP or BOOTP, configure the

way to obtain the address. If the address cannot be obtained

automatically or manual configuration is preferred, configure

the IP address, subnet mask, and gateway address.
a. Select

Protocol Settings

.

b. Select

TCP/IP - Get IP Address

and then select

Change

Settings

.

c. Select one from

DHCP

,

BOOTP

,

RARP

,

DHCP/Autonet

or

Manual

. If you select anything other than

Manual

,

proceed to step 4.

NOTE: When using a DHCP server, also configure the
WINS (Windows Internet Name Service) server.

d. Select

TCP/IP - Get IP Address

and then select

Change

Settings

.

e. Enter the IP address using the numeric keypad.

NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.

NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.

NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.

f. Select

Save

.

g. Configure

TCP/IP - Subnet Mask

and

TCP/IP - Gateway

Address

as shown above.

This manual is related to the following products: