Xerox 4590 - Manual (Page 36)

Xerox 4590/4110 Copier/Printer System Administration Guide 2-2
2. Configuration
Configuration on the machine
This section describes the configuration procedure to use TCP/IP
(LPD/Port 9100) protocol on the machine. First enable the LPD
Port or Port 9100 port, then assign the IP address.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to “Using CentreWare Internet Services” on page 3-1.
1. Display the
System Administrator Menu
screen.
a. Press the
Log In/Out
button.
b. Enter the UserID using the numeric keypad and select
Confirm
.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select
System Settings
.
2. Enable either the LPD port or the Port 9100 port as
appropriate. In this example, the LPD port is enabled.
a. Select
System Settings
.
b. Select
Network Settings
.
c. Select
Port Settings
.
d. Select
LPD
and then select
Change Settings
.
e. Select
LPD - Port
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select
Close
repeatedly until the
Network Settings
screen is displayed.
b. Select
Protocol Settings
.
c. Select
TCP/IP - Get IP Address
and select
Change
Settings
.
d. Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Manual
. If you select anything other than
Manual
, proceed
to step 4.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.