Xerox 4590 User Manual
Page 118

Xerox 4590/4110 Copier/Printer System Administration Guide
5-26
5. Using the Scan Service
g. Select
Save
.
h. Configure
TCP/IP - Subnet Mask
and
TCP/IP - Gateway
Address
as shown above.
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter “0.0.0.0.”
7.
Select
Close
repeatedly until the
System Settings
screen is
displayed.
8.
Select
Exit
.
9.
After the machine is restarted, print out the Printer Settings
List to confirm that the SOAP port is enabled and the IP
addresses are configured.