Konica Minolta bizhub 420 - Manual (Page 172)

Polling 9
bizhub 500/420 9-5
Polling
Chapter 9
9.2 Polling Reception
Polling reception enables the FK-502 to send a command to a destination to
receive the document that is either set for transmission on the remote ma-
chine or reserved for polling transmission. This function is convenient when
you prefer to bear the telephone charge instead of the destination.
You can designate two or more destinations for polling reception by using
sequential polling reception.
A sequential polling reception result report prints out upon completion of se-
quential polling reception. A sequential Polling RX reservation report prints
out when Timer TX is also used.
!
Detail
It may be unable to be used with the other party machine.
Refer to “Sequence Polling RX Reservation Report” on page 12-25 and
“Sequence Polling Reception Report” on page 12-15 for information on
the Sequential Polling Reception Reservation Report and Sequential
Polling Reception Result Report.
Polling Reception
Polling reception has two options: one is ordinary polling reception, and the
other receives the document reserved in the bulletin board of the destination.
The description below assumes the ordinary polling reception. For the latter,
see “Receive by Polling a Document Written to the Bulletin Board of a Des-
tination (FAX)” on page 9-11.
0 Functions incompatible
Frame Erase, Scan SIze, Mixed Original, Bind Position, Confidential TX,
Relay TX Req, ECM OFF, Overseas TX, Polling TX (Normal), Password
TX, V.34 OFF, Separate Scan, Bulletin Board Registration, Polling RX
(Bulletin)
1
Press [Fax] on the control panel to view the FAX screen, if it is not al-
ready displayed.
2
Press [Comm. Setting].