Konica Minolta bizhub 420 - Manual (Page 108)

Reception 4
bizhub 500/420 4-13
Reception
Chapter 4
!
Detail
If the size of the paper on which the facsimile actually prints is smaller
than that of the paper selected at step 1, the document is printed in re-
duced size.
When [Print Separate Fax Pages] is set to OFF, if the direction of the pa-
per on which the facsimile actually prints is different with that of the paper
selected at step 1, the document is automatically printed so that it can be
output appropriately rotated by a 90-degree angle.
If you print mixed size documents, this process is executed on each
page.
If the paper sizes selected in step 1 and step 2 are set in several paper
trays, the paper tray used is selected according to the setting of the au-
tomatic paper size selection function. Refer to the “User's Guide (Copy
Operations)” for more detailed information.
If the required paper size is only set in the manual insertion tray, the doc-
ument is printed on the paper fed from the tray; however, if the automatic
paper size selection function or the automatic tray selection function is
disabled on the tray, the tray is not selected.
Even if the page division is set to ON, the page will not be divided if the
[TX/RX Setting] is set as follows.
[Tray Selection for RX Print] is set
[Min. Reduction for RX Print] is set to [× 1.0]
[Print Paper Selection] is set to [Fixed Size] or [Priority Size]
[Duplex Print (RX)] is set to [ON]
If no printable paper is set, a message asking you to set the printable pa-
per appears.
If [Print Paper Selection] is set to [Priority Size]:
The appropriate paper is selected among 8.5 Ч 11, 8.5 Ч 14 and 11 × 17
(A4, B4 and A3). If it is not available, paper is selected as usual and re-
corded.
If [Print Paper Selection] is set to [Fixed Size]:
The appropriate paper is selected among 8.5 Ч 11, 8.5 Ч 14 and 11 Ч 17