beautypg.com

Loading paper into trays 3 and 4, Loading paper into trays 3 and 4 -4 – Konica Minolta BIZHUB C652DS User Manual

Page 211

background image

bizhub C652/C652DS/C552/C552DS/C452

8-4

8.1

Paper

8

Loading paper into trays 3 and 4

The same procedures can be used to load paper into trays 3 and 4.

The following procedure describes how to load paper into tray 3.

1

Pull out tray 3.

NOTICE

Be careful not to touch the surface of the paper take-up roller with
your hand.

2

Lift up the paper take-up roller, and then load the paper into the
tray.

% Load the paper into the tray so that the side of the paper to be

printed on (the side facing up when the package was
unwrapped) faces up.

% Do not load so many sheets of paper that the top of the stack

is higher than the mark.

% Do not load tray 3 with paper of a size other than that

previously specified.

% If paper is curled, flatten it before loading it.

% If special paper is loaded, the paper type must be specified.

% Load letterhead paper so that the side to be printed on faces down.

% To change the paper size for tray 3, contact your service representative.

3

Lower the paper take-up roller, and then close tray 3.

d

Reference

To configure paper settings:

Press [Basic] ö [Paper].

This manual is related to the following products: