Konica Minolta PAGEPRO 9100 - Manual (Page 94)

Solving Problems 88
The printer is
not receiving
data from the
computer.
(The Data
indicator
doesn’t blink
after a file is
sent.) The printer is not on
line. Put the printer on line and verify that the
message window displays IDLE.
The emulation has
been changed from
ESP to an emulation
that doesn’t match
the file you are
sending.
Print a status page. For information about
the ESP mode, refer to the Crown Books
in PDF on the Documentation CD-ROM.
The port setting is
incorrect.
For Ethernet, parallel, or USB
connections, set the port to Enabled.
When the parallel
cable is set to Inter-
active (the default),
and the parallel cable
is unplugged then
plugged back in,
communication was
lost. Set the parallel cable to Non-
Interactive mode in the Administration/
Communications/Parallel/Mode menu.
Too many
status pages
print. Your printer is set to
print the multiple-
page Advanced
Status Page instead
of the one-page Stan-
dard Status Page.
Select the type of status page through
the Administration/Special Pages/
Status Page Type menu on the control
panel.
In the
Security
menu with
Enable
Password
set, a telnet
session asks
for a pass-
word when
entering the
admin mode.
In the “Security/
Admin Menu” menu,
the password you set
will affect both the
admin mode and the
Admin Menu. Use the password you set for the
Security/Admin Menu for the telnet admin
mode.
Symptom Cause Solution