Konica Minolta PAGEPRO 9100 - Manual (Page 131)

Time-of-Day Clock 125
3
Attach the time-of-day
clock to the controller
board.
Attention
Make sure that the pins
on the time-of-day clock
are properly aligned with
those in the receiving
socket on the controller
board. Damage to the time-of-day clock and/or controller board
could result if the pins are misaligned.
a Locate the time-of-day clock socket on the controller board and the pin
1 notch or printed label.
b Locate the pin 1 indicator mark on the top of the time-of-day clock.
This mark may be a notch or a slight depression on one end of the
clock.
c Align this indicator mark with the pin 1 notch or printed label on the
controller board.
d Gently press down on the time-of-day clock until it’s firmly seated.
4
Reinstall the controller board.
Gently slide the controller board into the printer’s tracks until it is fully
seated, and then tighten the four screws.
5
Reconnect all interface cables.
6
Reconnect the power cord and turn on
the printer.
In compliance with UL guide-
lines, “The appliance inlet is
considered to be the main dis-
connect device.”
7
The presence of the clock will be automatically sensed.
8
Print a startup page.
The time-of-day clock is not listed under “Installed Options” on the startup
page, but the time does appear as System Date in the Printer Information
column.
Using the Time-of-Day Clock
For instructions about setting and using the time-of-day clock, refer to the
Crown Books in PDF on the Documentation CD-ROM.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII