Konica Minolta PAGEPRO 9100 - Manual (Page 118)

Dual In-Line Memory Modules (DIMMs) 112
Installing DIMMs
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 106. In addition,
always handle circuit boards by the edges only.
1
If you are not to the point
when you are able to
print an advanced status
page (with the control
panel’s Print Status?
button) yet, skip to
step 2.
If you have previously
installed your printer and
have confirmed that it is
printing, print an
advanced status page in
case you need to restore
any current memory settings after the DIMM installation.
Installing DIMMs automatically restores memory defaults. If your
memory settings are specific to your environment, print an
advanced status page before installing DIMMs, so you can recover
the current memory settings.
2
Turn off the printer and disconnect the power cord and all interface
cables.
3
Remove the controller
board.
Loosen four screws, and
pull the controller board
from the printer.
4
Position the controller
board on a flat surface
so it lies flat and the I/O
connector panel is
facing you.
If you want to
install more memory, you may exchange one or more DIMMs for
DIMMs with a greater memory capacity.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ .......... ................................................ ........................ ..........
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII