Konica Minolta PAGEPRO 9100 - Manual (Page 136)

Deinstalling Accessories 130
2
Detach the duplexer from the printer.
Attention
If the duplexer is released too
quickly, it may fall and break.
Be sure to keep the duplexer
supported until the screws are
loosened.
a Using the wrench supplied with
the duplexer, loosen the two
screws on the duplexer.
The two screws are attached to the duplexer and cannot be removed.
After using the wrench, keep it in a safe place for future use.
b Unhook the two tabs at the bottom
of the duplexer from the notches
on the back of the printer.
c Store the duplexer in its original
packaging.
4
Replace the cover on the back of the
printer.
Use the wrench supplied with the
duplexer to tighten it.
5
Replace the exhaust filter.