Konica Minolta PAGEPRO 9100 - Manual (Page 63)

Cleaning 57
Cleaning
When does the printer need cleaning?
What cleaning materials should I use?
Cleaning the Printer Exterior
Attention
Never spray cleaning solution directly on the printer’s surface; the
spray could penetrate through the air vents of the printer and damage
the internal circuits.
Clean this item thoroughly... After...
Exterior Once a month or as needed, whichever
comes first.
Interior (media feed rollers) Media stops being fed from the media
tray(s).
Note: We recommend that you do not clean elsewhere inside the printer. If necessary,
refer to the Service & Support Guide or printer.konicaminolta.com for a
KONICA MINOLTA-authorized service provider near you.
Exterior—Use Exterior—Avoid
A soft dry cloth to clean the control panel. Sharp or rough implements (such as wire
or plastic cleaning pads or brushes);
liquids.
A soft, wrung-out damp cloth to clean the
outside of the printer. Aerosol or pump-sprayed cleaners; too
much dampness in the cloth.
Mild neutral detergent to clean the outside
of the printer, if necessary. Abrasive or corrosive solutions that
contain solvents (such as alcohol,
benzine, or thinners).
Interior Media Feed Rollers—Use Interior—Avoid
A soft dry clean cloth. Sharp or rough implements (such as wire
or plastic cleaning pads or brushes); any
liquids.
Status
page Online Cancel MPSize
Select
Menu Select Previous Next
Data Ready Message