Konica Minolta PAGEPRO 9100 - Manual (Page 40)

Media Storage and Handling 34
Perforated, three-hole punched, or torn
Too slick, too coarse, too textured
Different in texture (roughness) on the front and back
Too thin or too thick
Stuck together with static electricity
Composed of foil or gilt; too luminous
Heat sensitive or cannot withstand the fusing temperature (392° F/200° C)
Irregularly shaped (not rectangular or not cut at right angles)
Attached with glue, tape, paper clips, staples, ribbons, hooks, or buttons
Acidic
Any other media that is not approved
Use media that is
Suitable for plain-paper laser printers, such as standard paper
What should I watch out for when loading custom media?
When printing on media that is longer than 14 inches (355.6 mm), use the
multipurpose tray extender and support the media with your hands under-
neath while it feeds through the multipurpose tray.
Select plain paper mode in Administration/Media/Plain Paper menu. Set the
printer for custom-sized media in the Operator Control/Multipurpose Sz/
Custom menu.
Do not use custom media that does not fit the approved dimensions
Width: 3.4 inches (86 mm) up to 11.7 inches (297 mm)
Length: 5.5 inches (139.7 mm) up to 17.0 inches (432 mm)
What should I watch out for when loading envelopes?
Do not use envelopes that have
Sticky flaps
Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for
sealing
Transparent windows
Too rough of a surface
Material that will melt, vaporize, offset discolor, or emit dangerous fumes
Been presealed
Use envelopes that are
Common office envelopes with diagonal joints, sharp folds and edges,
and ordinary gummed flaps